EGE 29

Dimensions :

Length overall : 8.80 m.
Length of waterline : 7.90 m.
Beam : 2.90 m.
Draft : 1.50 m.
Displacement : 2.650 kg.
Ballast : 980 kg.

CONSTRUCTION :

Hull : Hand made solid laminate fiberglass mat and rowing .
Deck : Deck is moulded fiberglass with sandwiched marine plywood, stress areas
where winches, sheet tracks, etc. are reinforced by using backing chrome plates.
Ballast : 880 kg. cast iron, torpedo shaped bottom. Keel bolts are of stainless steel.
Rudder : Glass fibre rudder on solid stainless steel stock (diameter 40 mm.).
Rudder trunk stock is screwed to the skeg on the hull with delrin hausings.
Motor bed : Glass fibre bed moulded to the hull.
Chain plates : Stainless steel fixed on the hull.
Interior joinery : Marine grade water proof plywood faced with selected mahogany or
american cherry is used in all bulkheads and major joinery. Specially selected solid mahogany or american cherry in frames and doors. Marine plywood in bottoms, shelves, etc. where not visible. All main bulkheads bonded to hull and deck using glass mat and polyester. All main visible hull sides covered by mahogany planking ribs. Ceiling, top sides and visible hull sides padded with foam backed vinyl. Hullsides, bottom, bilge, etc, topcoated throughout the interior. Varnished cabin sole, mahogany with ashtree inlaid wood stripes.

ACCOMODATION :

Forward : Double berth , stowage under the berth , shelves along hullsides sb and port.
Saloon : Settee on both sides. Table with fixed middle section and folding wings.
Stowage behind and under the settee on both sides.
Toilet compartment : Glassfibre unit. Lockers along hullside, moulded bottom section.
Galley : -L- shaped galley with 90 liters ice-box , sink, cutting board, dry food locker,
gas stove. The ice-box is drained. Waste basket.
Navigation area : Small navigation table with stowage. Electrical master panel mounted in bulkhead locker.
Aft cabin : Large aft cabin on port side with double berth and wardrobe. Shelves along hulside ,
stowage under the berth .

DECK EQUIPMENT :

-2 hatches, 5 openable, 3 fixed aluminum framed windows.
-2 16 STA Harken winches.
-4 mooring bollards,
-2 aluminum genoa tracks with rails. (Harken)
-1 main sheet track with slider and tag lines.(harken)
-Navigation lights.
-25 mm. diameter stainless steel pullpit, pushpit and ladder.
General ; Bolts, nuts, washers and screws used for fastening deck equipment are of stainless steel.
Sealing used between deck and equipment is polyurethane, silicone or specially developed material.

INTERIOR EQUIPMENT :

Fresh water system : 2x70 lt. capacity fiberglass tanks. Pressurised water. Filler line from deck. Tanks are ventilated.
Sink drained to waste water tanks. 2 waste water tanks and drainage pump with grinding.
12 volt bilge-pump.
Toilet installation : Hand operated marine toilet with sea water in take and outlet through ball valves.
Waste holding tank. Electric toilet is optional extra.
Shower : Shower on deck.
Cushions : Cushions in high quality foam with first class upholstery in choice of colours.
Electrical installation : Switchboard and control panel in navigators area. 1 lamp in toilet, 4 spotlights in main cabin,
1 reading light in aft cabin, 2 x 55 amp/hrs. marine batterys, 1 both shalter.
Gas system : 1 small gas bottle ( 4.95 liters) installed in separate, drained compartment
on aft. Reduction valve for low pressure system. Burner gas stove.
General Hardware : Doors have marine locks. Locker doors have finger snap locks and are hinged
with brass hinges.
General : Bolts, nuts, washers and screws are generally stainless steel. Hose clamps
are all stainless steel. Through bottom fittings and other piping fittings are
brass. Hoses are reinforced flexible pvc polyethylene.

ENGINE INSTALLATION :

Engine : 9 Hp. Yanmar with fixed propeller . Sea water cooled.
18HP and fresh water cooling are optional extras.
Controls : Lever controller and instrument panel in cockpit.
Fuel : 40 liters diesel tank in stainless steel . Filling from deck.
Engine housing : Easily removed engine housing with interior joinery finish, well insulated with foam.
Battery : 2 x 55 amp/hrs. battery with both shalter
MAST AND RIGGING :
Main mast : Zetspars brand (French)10.5 m. long mast with one level of spreaders,
boom and boomvang. Cenoa furler.
Standing rigging : All stays and shrouds in stainles steel wire.
Running rigging : 1 main halyard, 1 cenoa halyard, 1 main sheet, 2 jib sheets.
Sails : 1 main , 1 genoafurler , sail bags.

ELECTRONIC:
Autohelm brand, deep sounder and speed indicator and compass.

STANDART EQUIPMENT :
4 Mooring lines.
4 Fenders.
1 Anchor with chain.
1 Instruction manual.